The best cold-climate heat pump is one that maintains good capacity and efficiency in very cold weather, not just one that “operates down to -30°C.” Compare the ENERGY STAR cold-climate certification, the published capacity at -15°C, the HSPF2 rating for the same climate zone, the noise level, and the comprehensive warranty.
“Heats down to -30°C”: what this statement really means
The temperature shown in a brochure is the operating limit : below this temperature, the unit shuts off. It doesn’t indicate how much heat it produces at that temperature. On most heat pumps, heating capacity decreases as the outside temperature drops. Therefore, two units rated at -30°C can perform very differently on a night when the outside temperature is -25°C.
Let’s be frank: manufacturers rarely publish the exact capacity at -25°C in their brochures. None of the datasheets for the models we install provide a precise figure at -25°C. Therefore, we have used the data actually published: the limit temperature, the HSPF2 rating, and the performance at -15°C when the manufacturer specifies it. For precise ultra-low temperature capacity, request the certification sheet for the exact system.
The official criterion: ENERGY STAR cold climate
The ENERGY STAR 6.2 specification (revised in February 2026) defines what a “cold climate” heat pump is (verified on October 16, 2026):
- a COP of at least 1.75 at −15 °C (5 °F);
- a heating capacity at −15 °C equal to at least 70% of the capacity at 8 °C (47 °F);
- an HSPF2 of at least 8.5 for a ductless system (8.1 with ducts) and a SEER2 of at least 15.2;
- an order verification procedure that confirms these results under real-world usage conditions.
This certification also has a direct effect on your wallet: LogisVert grants $120 per 1,000 BTU/h of heating at −8 °C to an ENERGY STAR cold climate appliance, compared to $50 for an ENERGY STAR only appliance (verified on October 16, 2026, Hydro-Québec ).
Comparative table of wall-mounted models (12,000 BTU version)
Here we are comparing the most common size, 12,000 BTU (15,000 BTU for the Moovair Mistral). The data comes from our product sheets and the manufacturers’ brochures.
| Model | Heats up to | HSPF2 published | Performance at −15 °C published | Outdoor unit | Compressor warranty / parts / labor |
|---|---|---|---|---|---|
| GREE Vireo 12,000 | -30 °C | 9.5 | Maximum capacity 11,000 BTU/h, COP 2.9 | 52 dB(A) | 10/10/1 year |
| GREE Crossover 12,000 | -30 °C | 9.5 | Not published in the brochure | 52 dB(A) | 10/10/10 years |
| STELPRO Pro B 12,000 | -30 °C | 10.5 (region IV) | Not published in the brochure | 53 dB(A) | 10/10/1 year |
| OUELLET Pacific 12,000 | -30 °C | 9.5 | Not published in the brochure | 52 dB(A) | 10/10/1 year |
| ELIOS EMC 12000 Series | -30 °C | 8 (region V), 10.5 (region IV) | Up to 100% of the nominal capacity (range) | 56 dB(A) | 10/10/1 year |
| MOOVAIR Mistral 15,000 | -25 °C | Up to 9.2 (region 5, range) | Up to 85% of heating capacity (range) | Not indicated | 10/10/1 year |
| STELPRO Elite B 12,000 | -25 °C | 10.0 | Not published in the brochure | 53 dB(A) | 10/10/10 years |
| GREE Vita 12,000 | -25 °C | 8.5 | Not published in the brochure | 52 dB(A) | 10/10/1 year |
| OUELLET Harmony 12,000 | -25 °C | 8.5 | Not published in the brochure | 52 dB(A) | 10/10/1 year |
Sources: GREE Vireo brochure , STELPRO Pro B datasheet , Elios EMC brochure , Moovair M Series brochure , and the datasheets in our heat pump catalog . The “range” designations are “up to” values given for the entire series.
How to read this table without being tricked
HSPF2 is only comparable within the same region
HSPF2 depends on the climate region used for the calculation. According to Natural Resources Canada , region V represents most of southern Canada, while values are often published for the milder region IV. The Elios example clearly illustrates this: the same 12,000 BTU unit displays 8 in region V and 10.5 in region IV. An HSPF2 of 10.5 in region IV is therefore not “better” than an 8 in region V; it may simply be the same performance measured differently. When the region is not specified, it is most often region IV.
The nominal capacity is not the capacity in extreme cold.
The GREE Vireo 12000 brochure is informative: it states a nominal heating output of 12,000 BTU/h, 7,700 BTU/h at -8°C under certification conditions, and a maximum capacity of 11,000 BTU/h at -15°C with a COP of 2.9. The last two figures do not measure the same thing: one is a certification point, the other the maximum power the compressor can reach. The key takeaway is that a well-designed unit retains a significant portion of its power in very cold weather: for the Vireo range, the published COPs at -15°C range from 1.8 to 2.9 depending on the power output, whereas an electric baseboard heater has a COP of 1.
Noise is measured both outside and inside.
The outdoor unit’s noise levels of 52 to 56 dB(A) are measured under standardized conditions. In very cold weather, the compressor runs faster and the noise level increases. The unit’s location (away from a bedroom window, on a vibration-damping mount) is just as important as the technical specifications.
Our choices based on your situation
- You want data published in very cold weather : the GREE Vireo is the only model in this comparison whose brochure gives a capacity and COP figure at −15 °C for each power.
- For the most comprehensive warranty , the GREE Crossover and STELPRO Elite B both feature a 10-year warranty on the compressor, parts, and labor, as detailed in our product sheets. Please note: the Elite B heats down to -25°C, while the Crossover only operates down to -30°C.
- If you live in a poorly insulated house or one exposed to wind : aim for a model that heats down to -30°C and have the unit sized for your heating needs, not for air conditioning.
- If you are heating a secondary room or a well-insulated condo : a −25 °C model like the GREE Vita or the OUELLET Harmony may be sufficient, with your existing heating as a backup.
- You are aiming for the maximum subsidy : check the ENERGY STAR cold climate certification of the exact system before buying.
And what about a multi-zone or central system?
The same criteria apply to systems that heat multiple rooms. In our catalog, according to the manufacturers’ specifications:
- Multizone : the GREE Freematch, STELPRO Multi B and OUELLET Myriad all heat down to −30 °C, with published HSPF2s of 10 to 11 depending on the power, and a 10-year warranty on the compressor, parts and labor.
- Central : the STELPRO Slim B and OUELLET Flexx heat down to −30 °C, with published HSPF2 values of 9 to 10.2 and the same full 10-year warranty.
For a multi-zone system, the outdoor unit is larger and generally noisier than a single-zone unit: its placement deserves even more attention. To choose between a central system and wall-mounted units, read our comparison of central versus wall-mounted heat pumps .
Size matters more than brand
An excellent cold-weather heat pump that’s undersized will disappoint. Too small, it will leave your baseboard heaters running in very cold weather; too large, it will operate in short cycles and cost more. Natural Resources Canada recommends determining heating and cooling loads using a recognized method such as the CSA F280 standard. Our article “BTU Calculation: What Heat Pump Size?” explains the process, and our comparison of Stelpro, Gree, and Ouellet compares the brands in more detail.
Checklist before buying a cold climate heat pump
- Is the exact system (indoor and outdoor units) ENERGY STAR certified for cold climates?
- What is its maximum heating temperature according to the manufacturer?
- Does the manufacturer publish a capacity or COP at −15 °C?
- Is HSPF2 specified for region IV or region V?
- What is the noise level of the outdoor unit, and where will it be installed?
- What does the warranty cover: compressor, parts, labor, and for how many years?
- Was the sizing done according to your heating needs?
Frequently Asked Questions
Does a heat pump heat at -30°C in Montreal?
Several models we install operate down to -30°C according to their manufacturers, including the GREE Vireo and Crossover, the STELPRO Pro B, the OUELLET Pacific, and the ELIOS EMC Series. At this temperature, their capacity is generally lower than at 8°C: a supplementary heater remains useful during extreme cold.
What is an ENERGY STAR cold climate heat pump?
This is a certified unit that achieves a COP of at least 1.75 and retains at least 70% of its capacity at −15 °C, according to the ENERGY STAR 6.2 specification. In Quebec, this certification entitles you to the LogisVert rate of $120 per 1,000 BTU/h at −8 °C.
Which brand of heat pump performs best in very cold weather?
There’s no one-size-fits-all answer: performance varies depending on the model range and power output, even within the same brand. Compare models individually, using published data and in the same climate zone.
Does a cold climate heat pump cost more?
Often a little more at the time of purchase, but the higher LogisVert subsidy for cold climate models can reduce, or even reverse, the net price difference.
Want to know which model is right for your home? Get a quote : we’ll recommend a unit sized for your property and confirm your eligibility for a subsidy. Phone: 438.816.0992.




